HC06 Wireless Communication Bluetooth Module Master Slave Board For Arduino
Product DescriptionFeature: Size: 35mm (diameter)Fixing hole: 2mm, Pitch 1200mil (30.48mm)Voltage: 5V (Note: higher than this voltage will burn the module.)Current: not more than 50mAIO voltage: 3.3, 5VChip: HC-06Pin spacing: 2.0mm compatible with XBee pinCommunication distance: <10m (open s..
Size: 35mm (diameter)
Fixing hole: 2mm, Pitch 1200mil (30.48mm)
Voltage: 5V (Note: higher than this voltage will burn the module.)
Current: not more than 50mA
IO voltage: 3.3, 5V
Pin spacing: 2.0mm compatible with XBee pin
Communication distance: <10m (open space)
AT command can be sent through the serial port to set the name, baud rate, password and other parameters, power-down save parameters
Master-slave, you can switch from master to slave mode AT command
Host: used to search the slave device, can not be searched by other devices.
Slave: used to be searched, can not take the initiative to search for other equipment.
The master-slave connection is the equivalent of a serial port, and at this point the main slave, which is the penetration mode, can be paired with the machine to enter the mode of penetration. There is no match between the host and the host. The host cannot match the computer, cell phone, PDA, etc.
Slave and slave can not be paired, the slave can be paired with the host, paired with a computer, cell phone, PDA and other devices, the host after power on the initiative to find the last pair of devices, if need to search again press on the Reset button.
The default baud rate is 9600
Default pairing password: 1234
Default mode: slave (can be switched to host by AT command)
1 x HC06 Wireless Communication Bluetooth Module